Sheffield’s experienced supply chain managers maintain a large selection of coated coils. Coatings include Hot-Dipped Galvanized, Galvanneal, Electro Galvanized and Aluminized. Our coated products are available in a full spectrum of gauges, carbon content and sizes, and we’re confident we will meet and exceed your requirements in an effective, agile and professional manner. Please contact us to inquire about our ability to meet your coated steel needs.
SUPERIOR PRODUCTS
COATED CARBON COIL & SHEET
- Gauge range from .008″ through .125″
- Widths from 1.000″ to 72″
- Actual certifications on all material
- All grades through 80ksi
- Domestic and offshore sourcing
- Other alloys, gauges and widths are available based upon inquiry
| Substrate | Types |
| CS Type B | Galvanized |
| FS | Galvannealed |
| DDS | Galvalume |
| EDDS | Aluminized |
| IF | Electro Galvanized |
| HSLA | |
| Structural Grades |
CARBON COIL & SHEET DESIGN GUIDE
Galvanized Steel – is steel that has gone through a chemical process of coating it in layers of zinc oxide to keep it from corroding due to the fact that this protective metal coating doesn’t rust as easily. The coating also gives the steel a more attractive durable finish which is hard to scratch. For countless outdoor, marine, or industrial applications, galvanized steel is an essential fabrication component. Hot-dipped galvanization is the most common method used. A variation, continuous sheet galvanizing, runs it through the molten zinc but tends to leave a thinner layer of the protective metal. Painting and spraying don’t impart the strong bond of hot-dipping. While electro galvanizing or electroplating uses electricity to create a bond; it, too, results in a thin layer of zinc.
Galvannealed Steel – specialized steel produced by hot-dip galvanization followed by an immediate in-line annealing that imparts a very fine greyish matte finish. The coating doesn’t flake off when formed, stamped, or bent. The matte finish acts like a primer, allowing paint to easily adhere, and is very rust proof. With good paintability and long, reliable, service life, it finds extensive use in automotive, signage, electrical equipment, and other applications requiring these characteristics.
GALVALUME® Steel Sheet – is carbon steel sheet coated with aluminum-zinc alloy by a continuous hot-dip process. The nominal coating composition is 55% aluminum and 45% zinc. A small addition of silicon is included in the coating alloy to ensure good coating adhesion to the steel substrate when the product is roll-formed, drawn, or bent during fabrication. The coating offers the barrier corrosion protection of aluminum and the galvanic protection of zinc; it lasts a long time; provides cut-edge protection along sheared edges; outlasts a galvanized coating of comparable thickness; while maintaining a bright finish. As the preferred product for long-term resistance to atmospheric corrosion, it is the preferred material for roofing. Aluminized steel-is steel which is hot-dip coated on both sides with aluminum-silicon alloy, giving a tight metallurgical bond between the steel and its coating. It exhibits better behavior against corrosion and keeps the properties of the base material for temperatures lower than 800 °C (1,470 °F). Commonly used for heat exchangers in residential furnaces, commercial rooftop HVAC units, automotive mufflers, ovens, kitchen ranges, water heaters, fireplaces, barbecue and burners.
The information provided within is for descriptive and illustrative purposes, only. Please contact your sales professional at Sheffield, for any needed assistance
